From the HBD Archive
From: "John Myers, FM3-35, 351-5514" <JMYERS@T1ACC1.intel.com>
Subject: Scales, Thermomters
Date: 1992-03-27 17:06:10 GMT

A few requests,

I'm in the process of obtaining the last bits and pieces for my full
grain gravity fed brewing system. Can someone direct me to reasonably
priced 1) Scales, 10 to 20 lbs. 2) Tough one here: A compression fitting
thermomter. Ideally I would like to weld a stainless steel sleve to
my primary 15 gallon boiler so I have the ability to remove/replace
the thermomter as needed. Since this boilers top is a approximately
7' I would rather not go-up-top for readings.

Thanks,
John Myers

Back New Search

The posts that comprise the Homebrew Digest Searchable Archive remain the property of their authors.
This search system is copyright © 2008 Scott Alfter; all rights reserved.